English 19
Please inspect the following before contacting the Service Center in the event of operational
disturbance:
Water is not hot or not cold.
- Excessive dispensation of
hot water or cold water in
a short period of time.
- Unit is not yet connected
to electricity.
- Wait until the water
becomes cold or hot.
- Connect the cord to the
outlet and press the heater
and cooler switches.
Water is not being
dispensed out of the tap.
- Water gallon is empty.
- The pipe is stuck or
blocks something.
- Replace the water gallon
with a new one
- Turn off the switch cooling
to 4 hours, and then turn
the switch back.
Leak on the water gallon
support.
- Water gallon is leaking /
damaged.
- Replace water gallon with
a new one.
Loud noise during operation.
- Improper installation or
placement of unit.
- Install unit on even and
stable surface.
Part 6 : Problem & Solution
To Next Page
Loading...
