English 16
ED 770
- Make sure the air hole at the front and the back part of the drying machine (dryer) is not closed.
- The back part of the drying machine (dryer) will be very hot when it is turned on.
- Make sure the back part of the drying machine (dryer) is hard to be reached when the machine is
operating.
- Do not use connecting cable. The plug on the drying machine (dryer) must be connected directly
to the outlet.
- Install the filter on its place.
- Put the drying machine (dryer) where the outlet can easily be reached after installation.
- Clean the drying machine (dryer) (outside & inside part) from dust/dirt with moist fabric.
- Smell from the heater will disappear after the first period of heating.
Attention:
The drying machine (dryer) must be connected to the electrical source which has been connected to
the ground / grounding.
IMPORTANT: Heat is emitted by the drying machine at a temperature that can reach 60
0
C. Make
sure the unit is placed on the floor that can bear high temperature. When operating the unit, the room
temperature must not be lower than 5
0
C and higher than 35
0
C because it will affect the drying
performance.
Electric Connection
Every work that is connected with the electric in this unit installation must be done by experienced and
professional technician.
Warning: This unit must be grounded
The producer is not responsible for every form of damage and loss that is caused by not following the
safety guidance that has been given.
Before activating the unit, make sure that the electric supply is in accordance with unit specifications.
Part 1: Names of the parts
1. Top Board
2. Control Panel
3. Door
4. Front Panel
5. Side Panel
6. Filter
7. Flex Tube
8. Power Plug
9. Switch
10. Tumbling Box
To Next Page
Loading...
