English 21
Dry clean normal cycle petroleum
solvent only
Dry clean normal cycle with any
solvent
Drying machine (dryer) MODENA is designed specially for long term usage so that it does not need
complex maintenance. However, some maintenance procedures below are recommended for your
drying machine (dryer) maintenance.
Before doing the maintenance, make sure that the unit is not connected to the electrical source.
Control Panel:
Wipe with a soft cloth and moist. Do not use rough objects to clean. Do not spray the cleaner directly
to the panel.
Some liquid dirt remover products can damage the finish on the control panel. Use these products
away from the dryer (dryer) and immediately wash your control panel if there is a spill or splash of
liquid.
Steel Tumbler:
To clean steel tumbler, use a damp cloth with a gentle cleanser that can be used to clean the surface
of the stainless material. Clean the rest of the cleaner with a clean cloth.
Outside of the Machine Dryer (dryer):
Wipe with a soft cloth and moist. Do not use rough objects to clean. Protect the surface from sharp
objects.
Exhaust system Machine Dryer (dryer) ED 650:
Should be inspected and cleaned once a year to maintain optimal performance. The outer part of the
exhaust should be cleaned more frequently to ensure the operation of the dryer (dryer) right.
Filter Clean:
- Clean the lint filter before each use.Remove by pulling straight up.
- Cleaning Filter. Use wiping cloth wipe with your hand.
- Instal filter. If the filter is cleaned by damp cloth or in the water, please install
after the sun dry.
Doors:
periodically clean the inside of the door to eliminate yarn and clothing fibers. Hygiene affects the
effectiveness of the drying process.
Cleaning Cabinet and inner tube:
Use soft damp cloth wipe when cleaning cabinet and inner tube.
1. Not to rinse by water direct.
2. Not to use neutral scour wipe.
3. Not to use gasolene and alcohol wipe.
To Next Page
Loading...