19
the working condition before the power outage. Otherwise, system
will be in the “power-off” state. When in the power-on state, press
“ON/OFF” button to shut down the system. When in the power-off
state, press “ON/OFF” button to turn on the system. In this case,
the memory data at the time of power outage will be restored, and
the system will enter into the corresponding working condition.
(2) “+” Button ( Button on the Remote Controller)
This button is used cooperatively with the “BOOK” button
to adjust the booked time. The specific operation is shown in
the booking adjustment function.
Adjust setting temperature: temperature is adjusted in the
range of (Tmin)-(Tmin+1)-(Tmin+1)……75-(Tmin). The
temperature will increase by 1
o
C after “+” button is clicked for
once. Long pressing “+” button will render the setting
temperature to increase at the rate of 5
o
C/s. If no button is
pressed within 5s, the system will store the setting temperature
parameters and exit the temperature setting status.
(3) “-” Button ( Button on the Remote Controller)
This button is used cooperatively with the “BOOK” button
to adjust the booked time. The specific operation is shown in
the booking adjustment function.
NOTE
The “ON/OFF” button is the highest priority button among all
buttons in the system. That is, if you press it under all failure-
free working conditions, the system will enter into the
power-off state; no content is displayed in the power-off
state.
The number of the software version will be displayed after
the full-screen display for 2s (the double “8” digits will be
shown on the digital screen will turns into 01).
To Next Page
Loading...
