English 26
c. Installation to sink
- If the water system does not have direct disposal or mounting on a sink can not be done,
connect the drain hose to the sink. The drain hose must be placed at a height of between 60
to 90 cm. Use a hose hanger (U pipe) to hang the drain hose on the side of the sink so that
the hose does not fall to the ground. To prevent shifting tighten hose hose hanger on the wall
using a hook or tie it in tap water with a rope.
5. Water inlet connection
- Turn on the water faucet and let the water flow for a few moments until the water looks clear.
(This is a special case if you are using a new water system or for those who do not use the
water for long periods of time).
- Connect the inlet hose supplied with the machine to a tap with a ¾” thread.
- Do not use previously employed hoses.
- Installation should comply with local water authority and building regulations requirements.
- When there is a inlet valve at the back of the machine, it must be connected to a cold water
supply.
- If there are two inlet valve, one is connected to a cold water supply and the other is connected
to a hot water supply. Follow the indication of the picture below to complete the connection.
6. Connecting with electricity
- Make sure the voltage used is 220 volts and 50 Hz.
- Insert the power cord to the socket that is connected to the ground.
- Avoid using extension cables, adapters and multiple sockets.
To Next Page
Loading...
