English 30
- Clean the pump filter regularly. Make sure the
washing machine is empty and there is no
water in the tube. Ensure that electrical current
has been interrupted
- To clean it, place the container or cloth under
a cover or filters to accommodate the
remaining water disposal.
- Remove the filter by turning it counter-
clockwise and pull out.
- Clean the filter carefully. Rinse the filter to put
it under water spray. Make sure that the
particles contained in the filter has been lifted.
- Rinse the filter by putting it under water spray.
Make sure that the particles contained in the
filter have been lifted.
- Replace the filter into its place by turning it
clockwise until it clicks into position.
To clean the
water entry
filter
- Clean the water entry filter on a
regular basis or if the water filling time
is too long.
- Close the tap water and remove the
water inlet hose by turning it counter
clockwise.
- Clean the filter on the back of the
washing machine with a soft brush
and rinse with water.
- Plug back the water inlet hose as
previously.
- Filter should be checked every 6
months or more or often if there are
frequent interruptions to the water
supply.
Important:
If the machine is exposed to temperatures below 0°C, certain precautions
should be taken.
1. Turn off the water tap.
2. Unscrew the inlet hose.
3. Unhook the drain hose from the rear support and position the end of thishose and that of the
inlet hose in a bowl. Run the spin programme.
4. Disconnect the appliance.
5. Screw the inlet hose and reposition the drain hose.
6. When you intend to start the machine up again, make sure that the room temperature is above
0°C.
To Next Page
Loading...
