FR-W1819
Mykonos Instructions14
2. Hanging the Fan
10. Carefully reinstall the hanger ball onto the downrod, being sure
that the cross pin is in the correct position, the setscrew is
tightened and wires are not twisted (Fig. 2C).
11. Carefully lift the fan motor assembly up to the mounting
bracket and seat the hanger ball in the mounting bracket socket.
Make sure the tab on the mounting bracket socket is properly
seated in the groove in the hanger ball (Fig. 2D).
Rotate the socket assembly until the ball drops and locks into
the hanger bracket screw.
12. Secure the safety cable to the building structure using spring
washer, flat washer, and wood screw provided (Fig. 2B)
NOTE: Safety cable is required for all installations in Canada. Safety
cable is required for ceiling fan and light combinations over 35lbs. in
both flush and downrod models in the United States.
1. Attach the blade to blade arm using the screws from
washers as shown in (Fig. 3).
2. Fasten blade assembly to motor using screws supplied (Fig. 3).
3. Attaching the Fan Blades
To Next Page
Loading...
