FR-W1819
Mykonos Instructions20
6. Finishing the Installation
1. Secure all wire connections with supplied wire ties to assist in
canopy installation.
2. Tuck connections neatly into ceiling outlet box.
3. Slide the canopy up to hanger bracket and place the key hole on
the canopy over the screw on the hanger bracket. Turn canopy
until it locks in place at the narrow section of the key holes (Fig. 6).
4. Align the circular hole on canopy with the remaining hole on the
hanger bracket. Secure by tightening the one screw previously
loosened and the one previously removed. Adjust the canopy screws
as necessary until the canopy and canopy cover are snug.
1. Remove one of the three screws from the mounting ring and
loosen the other two screws (do not remove).
2. Place the key holes in the adapter plate over the two screws
previously loosened from the mounting ring. Turn the adapter
plate until the adapter plate locks in place at the narrow section
of the key holes (Fig. 7).
3. Tighten the two mounting ring screws previously loosened and
the one previously removed to secure the adapter plate.
7. Installing the Adapter Plate
To Next Page
Loading...
