FR-W2001
Renegade Instructions22
9. Controlling the Fan
Your fan was delivered to you with the included control
paired to your fan.
A: Light On/Off, Bright/Dim
B: Fan On/Off, Speed Up/Down
C: Season (Summer/Winter)
Air-Gap Switch: Pull tab to power off in case of emergency. Not
necessary for normal fan operation (only included with wall control).
NOTE: Your fan features 6 speeds. An audible tone will indicate when
the speed is increased or decreased. When the fan has reached the
minimum/maximum speed level the fan will beep twice.
NOTE: Pairing must be completed within 3 minutes of power
being applied to the fan receiver
Controlling Multiple Fans with Remote or Wall Controls
Your remote and wall controls are capable of controlling
multiple fans. A remote or wall control has the ability to control
an unlimited number of fans with the only limitation being the
Bluetooth® range of the control and fan.
Pairing a remote control or wall control to an additional fan(s) can
be performed in the same manner as described in the pairing section.
NOTE: Pairing must be completed within three (3) minutes of
powering the fan.
Synchronizing Control Across Multiple Fans
If you are controlling more than one fan with a remote control, there
is a possibility that their light state, fan state or fan direction can get
out of sync. To bring the fans/lights back into sync please follow the
instructions on the next page.
To Next Page
Loading...
