FH-W2004
TipTop Instructions20
8. Finishing the Installation
9. Installing Adapter Plate
1. Secure wire connectors with supplied wire ties.
2. Remove the motor from the hook on the mounting bracket. Slide
the motor up to the mounting bracket and twist lock the housing
into place. Screw in the 2 screws in the key holes and one
remaining hole. Tighten all 3 screws. Use Part E.
3. Install the trim ring as shown (Fig. 8A).
1. Remove 1 of 3 screws and loosen the others (do not remove).
2. Twist lock adapter plate into place.
3. Using the screw from the previous step, install the
adapter plate (Fig. 9).
To Next Page
Loading...
