24
The motor rotor is blocked;
There is not enough water in the bowl;
The pump suction filter is dirty;
The pump and the washing impellers are dirty.
THE MACHINE DOES NOT RINSE
There is no water in the system;
The tap is partially closed;
The supply pipe may be bent or squeezed;
The filter of the solenoid valve may be dirty;
The coil of the solenoid valve may be interrupted;
The small piston of the solenoid valve may be
blocked.
Pressure in the system is insufficient.
Faulty connections or inefficient conductors on the
coil circuit;
Programmer cam does not close the relative contact
The cold, manual (where present) rinse pushbutton
may be faulty;
Micro door may be faulty;
There is lime in the rinse circuit;
The sprayers may be obstructed or the rotating arms
blocked
THE MACHINE RINSES UNINTERRUPTEDLY
The solenoid valve is dirty;
The small piston of the solenoid valve may be
blocked.
THE WASH RESULTS ARE UNSATISFACTORY
The electric pump may be faulty or damaged;
The detergent is not suited to dishwashers;
There is no detergent in the bowl;
The impellers may be obstructed or damaged;
The washing impeller may be blocked;
The water temperature is insufficient;
The kitchenware has been loaded incorrectly;
The baskets have been used incorrectly;
The rinse cycle has not been carried out properly.
The crockery is lightly soiled;
The washing slits are partially obstructed;
The dishes or other crockery are overlapping;
There is dried-on food residue on the crockery due to
late washing.
The wash cycle may be inefficient;
The rinse cycle may be inefficient;
The rinse water may be too hard and contain
exceeding calcium and magnesium salts;
There is excessive surfactant concentration in the
rinse water.
The detergent or surfactant may not be suitable for
industrial dishwashers;
The wash water temperature may be too low.
THE WATER DISPENSER OF THE SURFACTANT IS
FAULTY
The small transparent suction tube may be bent;
The small suction tube may have a hole;
The small suction tube is not properly tightened to
the rubber seal;
The suction fitting of the dispenser is not tightened
properly.
Pressure in the system is insufficient;
THE ELECTRIC DISPENSER OF THE DETERGENT IS
FAULTY
The small tube inside the dispenser may be broken;
The small suction tube may be bent or damaged.
Faulty connection or inefficient conductors on the
motor coil circuit;
Detergent dispenser may be faulty
THE REGENERATION CYCLE DOES NOT START
There is no water in the water system or the tap is
closed;
The supply pipe may be bent or compressed;
The filter of the solenoid valve may be dirty;
The coil of the solenoid valve may be interrupted;
The small piston of the solenoid valve may be
blocked;
The connections on the coil electric circuit may be
faulty;
The relevant push-button is not giving power
ON-OFF switch is defective;
The coil may be interrupted;
THE DRAINAGE PUMP IS FAULTY
The coil may be interrupted;
The impeller of the drain pump may be damaged;
The drain pipe may be obstructed.
The drainage button may be faulty.
The pressure switch has intevened;
To Next Page
Loading...
