The coil of the solenoid valve may be interrupted;
The small piston of the solenoid valve may be
blocked;
The connections on the coil electric circuit may be
faulty;
The relevant push-button is not giving power
ON-OFF switch is defective;
The coil may be interrupted;
THE DRAINAGE PUMP IS FAULTY
The coil may be interrupted;
The impeller of the drain pump may be damaged;
The drain pipe may be obstructed.
The drainage button may be faulty.
The pressure switch has intevened;
REMINDERS FOR REPLACING COMPONENTS
BEFORE DOING ANY MAINTENANCE,
COMPLETELY DRAIN OUT ALL WATER,
SHUT OFF THE POWER SUPPLY AND
CLOSE THE WATER SUPPLY COCK.
AFTER REPLACING AN ELECTRICAL
SYSTEM COMPONENT, CHECK IT IS
CORRECTLY WIRED.
18. CLEANING THE INTERIOR
Check the condition of the inside of the appliance.
Remove any built-up dirt.
Remove the washing impellers every 2-3 days and
make sure that there are no food deposits inside.
Check the slits and clean thoroughly if necessary.
Make sure that the rinse arm can rotate freely.
Remove any residues that may obstruct the holes of
the nozzles by gently using a thin point.
Any marks on the appliance interior may be
removed using a cloth dampened with water.
Any disincrustation of the dishwasher must be
carried out only by a specialised technician.
To Next Page
Loading...
