ERROR CODES
Replace the temperature and humidity sensor
Replace the temperature sensor
Exclude the abnormal water level in the water tank and
ensure that the WF interface is connected
Replace the temperature and humidity sensor
liminate the abnormality of the display panel
connection line, and ensure that the DISPLAY interface
is connected
Eliminate the abnormality of the display panel
connection line, and ensure that the DISPLAY interface
is connected
Non-faulty, the dehumidifier will automatically resume
to operate after the temperature drops
Non-faulty, the dehumidifier will automatically resume
to operate after the temperature rises
NOTE: If the problems persist, please turn off and unplug the dehumidifier, and contact
MOISWELL customer service: service@moiswell.com
When El, E2 and E4 fault alarm, the dehumidifier can operate normally, but it cannot be controlled
intelligently. The dehumidifier will automatically resume to operate after the fault is eliminated.
※Special NOTE:
To Next Page
Loading...