MoJack EZ - Repair Instructions Manual

EZ Repair Instructions
Damaged Carrier Locking Pin Assembly
If additional help is needed, please call MoJack Customer Service: 1-877-575-3173.
© MoJack July 2012 Rev. 2
1
Review the Product Manual and Parts List for MoJack EZ at www.themojack.com. The detailed breakout
drawing includes all part numbers used in these instructions.
DO NOT attempt any repairs on your MoJack if there is a mower on the lift.
PROBLEM: Damaged Carrier Locking Pin Assembly
Probable
cause:
Not pulling out on the Locking Pin when lowering your mower or Key Ring coming off
Solution:
Replace Carrier Locking Pin #33
Tools needed:
• Hammer
• Small 1/8 pin punch
• Large 5/16 pin punch
• Two 19mm wrenches or two adjustable wrenches
Steps to make the repair:
1) Place the MoJack EZ lift on its side and position Crank Handle
#4 so that it cannot move.
2)
• Using a small punch, tap all parts of the existing Roll Pin #32
out of the hole at the bottom of the Lift Screw #1.
• DO NOT try to drill out a broken Roll Pin as it may cause
damage to the hole.
• Remove Flat Washer #27 from Lift Screw.