While holding the endpin jack from the
inside of the guitar, install the smaller
dress washer followed by the smaller
hex nut on the outside where the jack
is protruding from the guitar.
Using a small screwdriver or hex
wrench through the hole of the endpin
jack, hold the jack in place while
tightening the hex nut with an open
end ½’’ wrench or adjustable pliers.
Install the strap button and tighten
with pliers using rubber or leather to
protect the strap button.
NOTE: The end of the jack should be
perfectly fl ush or slightly protrude
past the strap button or the plug may
not fully click into the jack.
4.
5.
6.
To Next Page
Loading...