Mojotone NC-1 - User Manual

QUICK INSTALLATION:
Using a Phillips head screwdriver,
loosen the cork padded mounting
clamps on each side until the clamps
are fully open. Insert the pickup into
the soundhole from the treble side
and grab the pickup with your other
hand on the bass side to position the
pickup into place. You want the pickup
to be as close to the neck as possible.
Center the logo under the strings.
Tighten the clamps gently until the
pickup is secure while leaving the
cable out of the soundhole.
CAUTION: Do not overtighten the
clamps as it may cause damage to the
pickup or the guitar.
Install the included clip around the
knurled portion of the barrel sleeve
on the endpin jack if you don’t want to
permanently install the jack into the
guitar. The clip can be used to attach
the jack to your belt or guitar strap
to relieve the cable from stress while
plugged in.
1.
2.

Summary

Quick Installation Guide

Install Pickup into Soundhole

Insert pickup into soundhole, position near neck, center logo, and gently tighten clamps.

Endpin Jack Clip Attachment

Install clip around endpin jack barrel sleeve to attach to belt or strap for stress relief.

Overtightening Caution

Do not overtighten mounting clamps to prevent damage to the pickup or guitar.

Permanent Installation Procedure

Drill Endpin Jack Hole

Drill a 1/2" hole through the tailblock or enlarge the existing hole for the endpin jack.

Prepare Endpin Jack

Remove strap button, nut, and washer from endpin jack to allow barrel insertion.

Adjust Endpin Jack Length

Adjust barrel length to extend 5/16" to 11/32" outside the guitar.

Install Outer Nut and Washer

Install smaller washer and hex nut on the outside where the jack protrudes from the guitar.

Tighten Endpin Jack Nut

Hold jack from inside, tighten outer hex nut with wrench or pliers.

Install Strap Button

Install strap button and tighten with pliers, protecting the button.

Endpin Jack Protrusion Note

Jack end should be flush or slightly protrude for plug to click properly.

Secure Pickup Wire

Install clips inside guitar waist to securely hold the pickup lead wire out of the way.

Final Pickup Adjustment

Insert pickup again, tighten clamps, string guitar, and adjust pickup as needed.

Mojotone NC-1 Specifications

General

Brand	Mojotone
Model	NC-1
Category	Accessories For Music Instruments
Language	English