®
Table of Contents
Not under documentation control if printed. May be revised without notice. ©05-2014
Electronic version is available at www.moldmasters.com
Hot Runner User Manual Revision 18
vi
Checking Nozzle Tip Height ...............................................................................................11-9
Latching the Cavity Plate to the Manifold Plate (Hot Half)................................................ 11-11
Torque Settings................................................................................................................. 11-12
Section 12 - TIT Edge Gated System ............................12-1
Introduction .........................................................................................................................12-1
TIT Edge Gated System .....................................................................................................12-1
TIT Edge Gate Seals ..........................................................................................................12-1
Section 13 - Accu-Line System .....................................13-1
Accu-Line Body Assembly ..................................................................................................13-1
Pre-Assembly .....................................................................................................................13-2
Accu-Line Assembly Procedure..........................................................................................13-2
Section 14 - Melt-Disk System.......................................14-1
Introduction .........................................................................................................................14-1
Safety .................................................................................................................................14-1
System with cast in heater element ....................................................................................14-2
Melt-Disk Preparation / Cleaning ........................................................................................14-3
Nozzle Thermocouple Assembly ........................................................................................14-4
Melt-Disk Thermocouple Assembly ....................................................................................14-4
Assembly of Melt Disk to the Nozzle .................................................................................14-6
Melt-Disk System Start Up & Shut Down ...........................................................................14-7
Disassembly for Maintenance ............................................................................................14-7
Melt-Disk Reassembly after Maintenance ..........................................................................14-7
Section 15 - Melt-Cube System .....................................15-1
Introduction .........................................................................................................................15-1
Safety .................................................................................................................................15-1
Melt-Cube Components......................................................................................................15-2
Example Melt-Cube System ..............................................................................................15-3
Assemble Melt-Cube into Cavity Block...............................................................................15-6
Startup and Shutdown .......................................................................................................15-9
Maintenance - Replacing a Tip ...........................................................................................15-9
To Next Page
