Page 4 of 20
E Rev. G/ 09/2006
If defects or faults occur
The lifter must be switched off immediately if one
of the following conditions occur;
• damage to electrical devices or cables, or damage
to parts of electrical insulation
• damage or failure on safety devices
If the expected movement does not start when
the corresponding button is pressed, please
consult the fault finding table in the mainte
-
nance chapter to locate the fault.
Injury to personnel or equipment may occur if
Molift QUICK RAISER is used in an incorrect man-
ner and if:
• covers are removed by unauthorised personnel
• used incorrectly
• insufcient maintenance
• load exceeds maximum limit. The maximum
load stated in this manual and on the lifter is the
maximum load
• unauthorised repair of electrical devices or cables
Lift and transfer
The patient lifter may tip over if used incor-
rectly! Ignorance of warnings and instruc
-
tions may lead to personnel injury. Read in
-
structions carefully before attempting to lift
anyone.
Stand to the side of the user when lifting. Ensure that
arms and legs are clear of the lift, chair, bed etc. Try
to maintain eye contact with the user - this will help
the user feel safe and comfortable.
Pay close attention to your actions. Ensure
that both ropes of the sling are securely fas
-
tened to avoid the user slipping or falling.
Keep fingers, arms or similar away from trol-
ley during use! Danger of clamping between
knee support and trolley.
Molift slings shall ONLY be used to lift per-
sons. NEVER use the sling to lift and/or move
objects of any kind.
Safety precautions
General
This operator manual is valid for all types of QUICK
RAISER. Use and operation of the variants are ba-
sically similar and any major difference is clearly
noted in the text.
Before putting a Molift QUICK RAISER into oper-
ation, the operator must ensure that the lifter and ac-
cessories are in good working order, especially with
regards to safety.
All instruction and information in this manual re-
garding safety and general precautions must be read,
understood and followed carefully. Any disregard to
these precautions may result in personnel injury or
damage to the equipment. The lifter must be taken
out of service immediately, or not returned to serv-
ice, if faults and/or irregularities that may have in-
uence on the safety are discovered.
Safety devices and -equipment must not be re-
moved, disabled or in any other way altered. A
Molift QUICK RAISER shall only be used when all
safety devices and equipment is in place and fully
operational.
The lifter is designed for use in room tem-
perature, +10 to +40 °C. This should be
taken into consideration when transporting
the lifter, and therefore keeping it in a tem
-
perate part of the vehicle. Alternatively, the
lifter must rest in a temperate room until the
equipment has achieved proper working tem
-
perature.
Use under moist or wet conditions
The lifter is splash proof. If used in conjunction with
shower equipment, a protective plastic bag must be
used to cover the operator panel. Avoid direct show-
ering of the lifter. Permanent use in shower rooms is
not recommended and can - over time - lead to corro-
sion of details on the lifter. If used in shower rooms,
it is mandatory to prevent excessive use of water as
well as increasing service and maintenance.
To Next Page
Loading...
