12
13
N
Container-stop / Shelf-stop positions
Container-stop and
shelf-stop position
These two functions can be used to
limit the range of movement of the
sit-stand table (e.g. if a file cabinet
is located under the sit-stand table).
A container-stop position can be set
only in the lower half of the
movement range, a shelf-stop
position only in the upper half of
the movement range. If a container
stop position is set, it is used as the
lower end position, while a
shelf-stop position corresponds to
the upper end position of the
movement range.
To activate a container- or shelf-stop position, follow these steps:
1. Move the sit-stand table to the position that you want to define as a new
container- or shelf-stop position.
2. Press the button on the left side and the UP and DOWN buttons simul-
taneously for 10 seconds. The control unit confirms the successful
activation with a double-click sound.
To deactivate a container- or shelf-stop position, follow these steps:
1. Move the sit-stand table to any position in the lower half of the movement
range to deactivate the container-stop , or in the upper half of the
movement range for the shelf-stop position.
2. Press the button on the left side and the UP and DOWN buttons simul-
taneously for 10 seconds. The control unit confirms the deactivation with a
single click sound.
Enabling single-hand operating
The table can be permanently set to single-hand operating so it can be
adjusted using the "UP" and "DOWN" keys without pressing the left
button. Please disconnect the mains plug from the socket before
changing this setting! Remove the plastic cover on the right bottom
side of the desk (4 screws, see picture) to get access to the toggle
switch.
Reinstall the plastic cover and connect the desk to mains.
Important safety note
The two-hand operating is a safety feature of the desk! The conversion to
single-handed operating is at the user's own responsibility!
Toggle switch towards the front side
of the desk = Two-hand operating
Toggle switch towards the back side
of the desk = Single-hand operating
To Next Page
Loading...
