User’s manual – E Bikes
Momabikes –All rights reserved Page5
3. BIKE’S UNPACKING, INSTALLATION, SETTINGS AND
MANTENANCE
Refer to the corresponding section in the User’s Manual of ordinary bikes,available at
www.momabikes.com.
4. GENERAL INFORMATION
We recommend not using the Bike under the rain, particularly under driving rain.
The electronic components, such as the motor, battery, controller, must not be
drownedin water.
How to connect the motor:
- Ebike20 / Ebike26 / Ebike28 / EMTB26 with battery in the frame
o Turn the battery key to the ON position and turn on the handlebar
display.
- Ebike28 Pro / EMTB27.5 / 29 / EMTB FS 27.5 / 29
o Press the power button on the battery (it will light up in blue) and then
press the Power button on the handlebar display. The key is only for
removing the battery.
- E16een / EMTB26 with battery in the rear rack
o Press the power button on the left of center bar in the frame (next to the
charger and USB) and then press the Power button on the handlebar
display. The key is only for removing the battery.
The brakes disconnect the motor*: when either of the 2 brake levers is activated, the
motor will automatically switch off. Try not to keep your hands on the brake levers, as
any slight pressure could cause the engine to stop running.
*Not applicable to bicycles with hydraulic disc brakes (EMTB27.5 / 29, EMTB FS 27.5
/ 29 and Ebike28 Pro).
Some of the components such as the battery, motor or controller, must be manipulated
by professionaltechnicians only.
To Next Page
Loading...