User’s manual – E Bikes
Momabikes –All rights reserved Page6
5. BATTERY
Before the first use, make sure the battery is fully charged.
In order to optimize the battery’s life, you should always leave it fully loaded, and load
it once a month if you do not use the Bike.
To charge the battery, first connect the plug to the battery; secondly, connect it to the
power grid. The red light of the charger will turn on, which indicates the battery is
charging. When the battery is fully charged, the red light will turn green.
You always have to disconnect the battery from the power gridafter charging. When you
want to disconnect the charger, do it firstly from the electricity network and secondly
from the battery.
Charge the battery during 12h before the first use.
The 3 following charges must be continuous and last 12h too.
Never leave the charger connected to the power grid when it is not used.
VERY IMPORTANT:
CHARGE THE BATTERY DURING 12H
BEFORE THE FIRST USE.
DO NOT LET THE BATTERY RUN
DOWN.
We recommendcharging it every time you
use the bike, and to never let the battery run
down completely. In case it would run down
entirely, the charger may not be powerful
enough to recover the battery.
To Next Page
Loading...