35
The display might show error codes (E1: problem with accelerator; E2/E3/E4: problems with battery voltage; E5/E6: problem with the
engine). In these cases, do not use the electric kickscooter anymore and contact your Dealer or the after-sale-service.
BATTERY LEVEL
The display shows the battery level.
During use of the kickscooter, when the battery is fully charged, the 5 lights are powered.
When 4 lights are on, the battery has full power.
When 3 lights are on, the power is at 85%.
When 1 light is on, slow-down, stop and provide for a new battery charge.
After turning-on the electric kickscooter, verify the level of the battery power on the display, and put one foot on the pedal.
Stand on pedal with one leg only.
Press the speed button on the right handle to accelerate.
Step on with the other foot whilst the kickscooter is moving.
Release the accelerator button to slow-down.
Press the brake on the left handle to brake.
When desired, but mainly when driving at high speed, you can use the rear wheel brake system (put the feet on the bumper of the rear
wheel).
Stop the kickscooter and remove the feet, one by one.
To Next Page
Loading...
