What to do if LED PROT. lights up on Monacor Carpower HPB-602?
If the protective circuit is activated on the Monacor Amplifier, the LED PROT. lights up. If the amplifier overheats, it will automatically switch on again after cooling down. If there's a short circuit at the speaker outputs, after fixing the short circuit, briefly switch off the 12 V control voltage (e.g., switch off the car radio) to reset the protective circuit.
How to fix Monacor Carpower HPB-602 if LED POWER does not light up?
To resolve the issue where the LED POWER does not light up on your Monacor Amplifier, check the fuses of the car HiFi power amplifier HPB-602: 1 x 30 A HPB-1502: 2 x 30 A and the additional fuse at the car battery HPB-602: 30 A HPB-1502: 60 A. Replace any defective fuses, ensuring you only use fuses with the indicated values.
General| Channels | 2 |
|---|---|
| Output Power (RMS) at 4 Ohm | 2 x 60 W |
| Signal-to-Noise Ratio | > 90 dB |
| THD | < 0.05% |
| Input Sensitivity | 0.2 V - 6 V |
| Input Impedance | 10 kOhm |
| Frequency Response | 10Hz - 30kHz |
| Power Supply | 12V DC |
| Type | Car Audio Amplifier |
| Low Pass Filter | 40 Hz - 250 Hz |
| Crossover Frequency | 40 Hz - 250 Hz |
To Next Page