To Next PageTo Next Page
Need help?Do you have a question about the Monacor PA-1122 and is the answer not in the manual?
Details on the front panel controls and indicators, including level, CLIP, PWR, PROT, and TEMP LEDs.
Description of rear panel connections such as power, speaker outputs, and signal inputs/outputs.
Instructions for mounting the amplifier in a standard 19-inch rack, including space and mounting requirements.
Guidance on connecting PA, monitor, and 8-ohm speakers, including load capacity limits.
Details on connecting audio sources and using feed-through outputs via XLR or screw terminals.
Instructions for connecting mains power and setting up a 24V emergency power supply.
Step-by-step guide to powering on, adjusting volume, and using the high-pass filter.
Details on the front panel controls and indicators, including level, CLIP, PWR, PROT, and TEMP LEDs.
Description of rear panel connections such as power, speaker outputs, and signal inputs/outputs.
Instructions for mounting the amplifier in a standard 19-inch rack, including space and mounting requirements.
Guidance on connecting PA, monitor, and 8-ohm speakers, including load capacity limits.
Details on connecting audio sources and using feed-through outputs via XLR or screw terminals.
Instructions for connecting mains power and setting up a 24V emergency power supply.
Step-by-step guide to powering on, adjusting volume, and using the high-pass filter.
General| Equalizer | Bass, Treble |
|---|---|
| THD | <0.5% |
| Power Output | 120W |
| Input Sensitivity | 0.775 V |
| Impedance | 4 Ω |
| Power Supply | 230 V / 50 Hz |
