22
REPLACEMENT OF THE FREEWHEELING SPROCKET
Remove left and right frame cover. See REPLACEMENT OF BRAKE BELT.
Dismantle the chain as described on page 20 - 21.
Loosen the axle nuts and lift off the flywheel. Remove the axle nut, washer, chain
adjuster and spacer on the freewheel side. Place the special remover (part No. 9100-14)
in the adapter and place the spacer and axle nut outside. See fig 15.
NOTE: Do not tighten the axle nut completely. It must be possible to loosen the adap-
ter-sprocket half a turn.
Replace sprocket-adapter and assemble the new parts in reverse order according to the
above.
LUBRICATION SPROCKET
The sprocket should be lubricated with a few drops of oil once a year. Incline the cycle
somewhat to make it easier for the oil to reach the bearing. See fig 16.
To Next Page
Loading...
