Mongoose 6061 - Attach The Brake Cables

Assembly 3
21
21
Figure 3.8
Figure 3.9
Figure 3.10
There are four brake opons, Caliper, Linear Pull, Disc and
Hydraulic Disc. If you have hydraulic disc brakes, see the manual
on hydraulic disc brakes that came with your bicycle.
Follow these steps if the brake cables are not aached to the
brake levers:
❶ Rotate the cable adjustment barrel and cable nut unl the
slots are aligned with the slot on the brake lever body.
Figure 3.8
❷ Press the brake lever towards the grip.
❸ Slide the brake cable through the slots and place the cable
head into the brake lever. Figure 3.9
❹ Release the brake lever. Figure 3.10
❺ Lightly pull on the cable and rotate the cable nut and cable
barrel so they are no longer aligned.
Note: See Secon 4: Adjusng the Brakes if adjustments are
needed.
Failure to properly set the brakes may result in the inability to
stop the bicycle movement and cause serious injury or death.
Be sure the brakes are funconing properly before using the
bicycle.
ATTACH THE BRAKE CABLES
WARNING!
Cable adjustment
barrel slot
Cable nut slot
Brake cable slot
Brake lever
Cable head
Brake cable
4
2
5
3
1