18
I. PLACING OF THE BATTERIES:
WARNING! The placement of batteries should be performed in the absence of children!
1. The batteries are not included in the set.
2. Remove the screw of the lid of the battery compartment with a screwdriver and set it aside.
3. After that place 2 pcs AAA (LR03) batteries in the compartment, make sure that you observe the respective polarity (+/-)
when you place them, it is indicated on the bottom of the compartment.
4. Replace the cover of the battery compartment and secure it with the screw.
5. The batteries must be handled by an adult. Do not allow the children to play with the batteries.
6.Warning! The placing of the further change of the batteries must be done by an adult.
II. BUTTONS OF THE REMOTE CONTROL – SEE FIGURE RC:
- F – Forward – press in order to move the car forward;
- B – Backward – press in order to move the car backward;
- P – Stop/ Pause – press to stop the car from moving;
- L – Turn on the left– press in order the car to turn on the left;
- R – Turn on the right – press in order the car o turn on the right;
- S – Speed select – 3 speeds – slow, medium and fast. When the car moves backwards, it is always only in slow speed.
- SI – LED indicating light for the speed – 1 LED light = slow speed; 2 = medium and 3 = fast speed;
III. CONNECTING THE REMOTE CONTROL DEVICE TO THE CAR:
1.Put batteries in the compartments of the remote control. Turn off the power of the car from the button on the dashboard.
Hold the Forward and Backward buttons at the same time for 3 seconds. The first speed indicator will start flashing. Turn on
the power of the car. The light indicator should stop flashing and turns to long light. This means that the connection was
successful.
2.If the connection wasn’t successful, turn off the power of the car and repeat step 1.
3.The RC will turn into power saving mode automatically if you do not use it for 10 seconds.
4.The RC device has memory function. This means that if you change the old batteries with new ones, you will not need to
reconnect the RC device to the car.
➢Moni Trade Ltd., hereby, declares that this type of radio equipment model KL-5088-1 complies with Directive
2014/53/EC. The complete text of EC declaration for compliance can be found at the following Internet address:
www.moni.bg.
IV. INSTRUCTION ON REMOTE CONTROL USE
Switch the power of the car on. The sounds will switch on as well. Turn on the power of the remote control. Based on the
desired movement (forward/backward/ left/right) press the right button. When the car is not in use, set the power switch of
the car at “OFF”.
V. IMPORTANT INFORMATION ABOUT THE BATTERIES:
1.Always remove the discharged batteries and do not throw them away with the household waste, use the places designated
for that purpose. They are recyclable.
2.Use only batteries with the size and voltage, marked on the bottom of the battery compartment.
3.Alkaline batteries are recommended.
4.The non-rechargeable batteries should not be charged.
5.Always remove the batteries, if you will not use the product for a long period of time.
6.the batteries without any left charge, should be immediately removed from the device.
7.When you replace the batteries always replace them with new ones, always replace all batteries.
8.The batteries are not toys. Children should not be present while you are replacing the batteries.
9.Do not mix old batteries with new ones.
10.Do not mix alkaline, standard (Carbon - Zinc), or rechargeable (Nickel – Cadmium) batteries.
11.Do not throw the batteries in fire, because they may blow up or leak.
REMOTE CONTROL USE
ONLY AN ADULT CAN USE THE REMOTE CONTROL!
The use of the remote control is always with priority over the manual and pedal operation with the car.
(If you use the remote control, the pedal will not work.)
Follow strictly the instructions regarding the remote control use.
CHARGING OF THE RECHARGEABLE BATTERY OF THE TOY
THE RECHARGEABLE BATTERY MUST BE CHARGED BY AN ADULT ONLY.
1.Before use for the first time you must charge the rechargeable battery for 8 - 12 hours. Do not charge more than 15 hours
to avoid overheating of the battery and charger.
2.Charge battery after each use or at least once a month for 8 to 12 hours but not more than 15 hours.
3.When the normal speed of the car starts to significantly decline or after each use of the product, charge the battery.
4.Check the battery, charger and their connectors and cables for extensive wearing or damage every time before you start
charging the battery. If you find any wearing or damage, do not use the charger or battery until the worn or damaged part is
replaced.
To Next Page
Loading...
