Monitor Audio ASB-2

s
0
u N D 8
A R
Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: ( 1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
le present appareil est conforme aux CNR d'lndustrie Canada applicables aux appareils radio exempts de licence. l'exploitation est autorisee aux deux
conditions suivantes : (1) l'appareil ne do it pas produire de brouillage, et (2) l'utilisateur de l'appareil do it accepter tout brouillage radioelectrique subi,
meme si le brouillage est susceptible d'en compromettre le fonctionnement.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
Conformement a la reglementation d'lndustrie Canada, le present emetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal
(ou inferieur) approuve pour l'emetteur par lndustrie Canada. Dans le but de reduire les risques de brouillage radioelectrique a l'intention des autres
utilisateurs, it faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnee equivalente (p.i.r.e.) ne depasse pas l'intensite
necessaire a l'etablissement d'une communication satisfaisante.
MPE Reminding
To satisfy FCC RF exposure requirements, a separation distance of 20 em or more should be maintained between the antenna of this device and persons
during device operation. To ensure compliance, operations at closer than this distance is not recommended.
les antennes installees doivent etre situees de facon a ce que la population ne puisse y etre exposee a une distance de main de 20 em. Installer les
antennes de facon a ce que le personnel ne puisse approcher a 20 em ou mains de la position centrale de l' antenne. la FCC des eltats-unis stipule que cet
appareil doit etre en tout temps eloigne d'au mains 20 em des personnes pendant son functionnement.