Need help?Do you have a question about the Monitor Audio Platinum 3G Series and is the answer not in the manual?
General| Series | Platinum 3G |
|---|---|
| Category | Speakers |
| Manufacturer | Monitor Audio |
| Type | Floorstanding |
| Sensitivity | 90 dB |
| Nominal Impedance | 4 ohms |
| Bass Driver | 8" RDT III |
| Tweeter | MPD (Micro Pleated Diaphragm) |
| Midrange Driver | 4" RDT III |
Outriggers are fitted for non-carpeted floors; position and check stability.
Screw spikes into feet for carpeted floors; ensure no wires are damaged.
Use a spirit level and hex key to adjust feet for a level speaker.
Details fitting self-adhesive rubber feet for the Platinum 100 3G.
Positioning speakers for an equilateral triangle in a 2-channel setup.
Ideal angles and positions for surround sound systems (5.1/7.1).
Positioning guidance for overhead channels in Dolby Atmos systems.
Connects speakers using a single set of cables to terminals.
Uses separate cables for bass and treble drivers, requires removing terminal links.
Connects two amplifiers to separate speaker terminals for bi-wiring.
Process for breaking in speakers over 50-70 hours for optimal performance.
How to use port bungs to manage bass response in certain room conditions.
Instructions for dusting, cleaning, and reviving speaker cabinet finishes.
How to tighten the retention bolt for driver mounting.
To Next Page