Monitor Audio Monitor 200 User Manual

owners manual
MONITOR SERIES

Monitor Audio Monitor 200 Specifications

General

Sensitivity	88 dB
Nominal Impedance	8 Ohms
Minimum Impedance	4.5 Ohms
Crossover Frequency	2.8 kHz
Power Handling	120 W
Recommended Amplifier Requirements	30 - 120 W
Bass Alignment	Bass reflex
Drive Units	1 x 25 mm (1") C-CAM gold dome tweeter

Summary

Spikes and Feet

Positioning

Wiring Configurations

Single Wire

Bi-Wire or Bi-Amp

Port Bungs

MRW-10 Amp Panel & Controls

1. RCA Stereo Inputs (Left & Right)

How to connect the subwoofer using RCA stereo inputs for a stereo amplifier.

2. LFE Input (RCA Type)

How to connect the subwoofer using the LFE input for an AV receiver.

3. 12 Volt Trigger Input ~ Centre Pin = +12Vdc

4. Crossover Frequency Control

MRW-10 Subwoofer Controls

5. Volume Control

6. Bass Switch

7. Phase Control Switch

8. Power Mode Switch with On-Auto Facility

10. IEC Mains Power Connector/ Fuse Location

Location and replacement of the IEC mains lead and fuse, with safety warnings.

11. Mains Voltage Selector

Information on the mains voltage selector and the importance of not adjusting it.

MRW-10 Positioning & Initial Set Up

MRW-10 Set Up

Trouble Shooting

My subwoofer will not turn on/ no power.

Steps to diagnose and fix power-related issues with the subwoofer.

No sound from subwoofer.

Steps to diagnose and fix issues where the subwoofer is not producing sound.