Monitor Audio Monitor 200 User Manual

Trouble Shooting
Should you experience any technical, or set-up problems with your subwoofer please check the Trouble
Shooting Guide below:
My subwoofer will not turn on/ no power.
• Check your mains lead is properly connected both at the subwoofer and at the mains outlet. Also
check the fuse of the mains plug (where fitted) and also the fuse in the subwoofer. See page 6 for
further information on changing the fuse and it’s location.
• Is there a signal going to the subwoofer? If there is a signal present, is the Power Mode Switch in
the Auto or On position, and the source is turned on? Try adjusting the volume level of the source
and try the switch in the ‘On’ position.
If it still does not turn on/ power up, please contact your local dealer/ distributor or Monitor Audio
immediately.
No sound from subwoofer.
• Are the signal leads connected correctly? Check these. If possible, check with a second, known to
be working set.
• Is the volume level just very low?
If it still does not output a signal, please contact your local dealer/ distributor or Monitor Audio
immediately.
Owner Information
Product Details
Model .................................................................
Product Serial No ................................................
Date of Purchase ................................................
Dealer Details
Dealer Name .....................................................................................................................
Address .............................................................................................................................
...........................................................................................................................................
E-mail address ...................................................................................................................
Telephone Number ............................................................................................................
Monitor Series10

Monitor Audio Monitor 200 Specifications

General

Sensitivity	88 dB
Nominal Impedance	8 Ohms
Minimum Impedance	4.5 Ohms
Crossover Frequency	2.8 kHz
Power Handling	120 W
Recommended Amplifier Requirements	30 - 120 W
Bass Alignment	Bass reflex
Drive Units	1 x 25 mm (1") C-CAM gold dome tweeter