13
© Monitor Audio 2005 Rev 2
Fine-tuning
1. Connect the mains supply and switch on the Radius 360/720. Play the music/
movie at an average listening level; the Subwoofer should switch on automatically
(blue LED on front will illuminate)
2.The volume control can now be adjusted to a desirable level.
3. The frequency control can now be set to give a seamless sound balance. The
setting will depend on the low frequency response of the main/satellite speakers.
4. The volume may need to be fine-tuned to complete the installation process. It is
very important to try a variety of music/movies with which you are familiar in order
to obtain the optimum overall settings.
Troubleshooting
No sound from the subwoofer
Check that the power connection is made correctly.
Check to see if the power light is on.
Check the input connections to the subwoofer are correct.
If the amplifier input is in use, check the connections are phased correctly
(+ to + and - to -).
If the amplifier input is in use, check the speaker wires are connected at
the amplifier.
Excessive bass from subwoofer
Check the position of subwoofer - ensure that it is not too close to a
corner of the room
Re-check the set-up procedure
Inadequate bass from subwoofer
Re-check full set-up procedure
Vibrating noise from subwoofer
Check that this is not caused by items located on top of or close to the
Subwoofer, which may vibrate when subject to deep bass sounds
If problems persist contact your dealer for assistance.
To Next Page
Loading...
Need help?
General
