Monogram ZIS420D - Page 17


STEP 12A (continued)
Custom Handles
,I\RXDUHXVLQJFXVWRPKDQGOHVWKHKDQGOHPXVW
be properly secured to the overlay panel before sliding
the panel into the trim.
7KHFDELQHWPDQXIDFWXUHUZLOOVXSSO\WKHFXVWRP
handle and hardware.
'LVFDUGWKHVXSSOLHGKDQGOH
5HPRYHWKHWULP3HHODZD\DIHZLQFKHV
of the adhesive backing.
IMPORTANT: 7KHWDSHLVYHU\VWLFN\DQGVWURQJ2QFH
it adheres to a surface, it cannot be removed without
damaging both surfaces. Do not install the trim before
the final wood panels are in place. Be sure to align
the trim carefully before removing the paper backing.
Reinstall all original screws.
5HLQVWDOOWKHKDQGOHVLGHWULPXVLQJDOOVXSSOLHG
flat-head screws, plus the 12 flat-head screws
originally installed in the handle trim.
,QVWDOODVXSSOLHGHQGFDSRQWRWKHWRSRIWKHGRRU
using a Phillips head screwdriver and the 2 screws
provided. Hand-tighten the screws into the end caps.
Do not overtighten; damage will occur.
&OHDQWKHDOXPLQXPWULPZLWKUXEELQJDOFRKRO³
do not use alcohols with oil or lanolin that will prevent
adhesion of double-sided tape.
6OLSWKHDOXPLQXPFRYHUWULPEHKLQGWKHWRSHQGFDS
WRFKHFNWKHILW7KHDOXPLQXPFRYHUWULPKDVDUHFHVV
on each end which fits the end cap.
Installation Instructions
Top End Cap
Fits Over the
Aluminum Trim.
Secure Cap with
2 Screws.
End Cap
STEP 12A (continued)
&DUHIXOO\SODFHWKHDOXPLQXPFRYHUWULPLQWRWRS
end cap so that the recess is aligned with the cap.
8VHWKHWRSWRERWWRPJURRYHVDORQJWKHKDQGOHVLGH
to align the cover trim accurately. Pull the tape a few
inches at a time while pressing the trim against
the door. Press and hold approximately 10 seconds
before continuing along the length of the door.
,QVWDOODQRWKHUHQGFDSDWWKHERWWRPRIWKHGRRU
WRVHFXUHWKHFRYHUWULP8VHDVWXEE\3KLOOLSVKHDG
screwdriver and the 2 screws provided.
 NOTE: Make sure there are no gaps in the installation.
)ROORZWKHVDPHSURFHGXUHRQWKHRSSRVLWHGRRU
Insert Aluminum
Trim Into End
Cap.
Cover Trim
End Cap