To Next Page
A
Alice ZimmermanAug 10, 2025
Why won't the console on my Monosem Cut-off machines switch on?
- TTracey SuarezAug 10, 2025
If the console of your Monosem Cut-off machines won't switch on, several issues could be the cause: * A burnt-out fuse: Inspect the fuse and replace it with one of the same amperage if necessary. If it burns out again, inspect the wire harness. If the wire harness is OK, contact after-sales service. * Faulty battery connections: Clean and retighten them. * Faulty battery cables: Replace or repair the cables. * Insufficient battery voltage: Ensure the battery voltage is at least 10 volts. Recharge or replace the battery if it's lower. * Inverted battery polarity: Connect the wires to the battery correctly.
General
