Monster Moto MM-E250 - Basic Maintenance: Tires and Electrical; Tire Pressure Check and Fuse Replacement

855-833-6483 OR EMAIL US AT info@monstermoto.com
PROBLEMS? DO NOT RETURN TO STORE! CALL US!
Basic Maintenance
Locate the valve stem on the res and check re
pressure. If it is not between 20 and 40 psi, add (or
deate) unl your pressure is correct.
For the rear re, access the valve stem between the
re and brake rotor. If you need to inate the re and
are not able to do so with a standard air chuck, use
and extender to access the valve stem.
3) Tire Pressure
Before you begin, make sure the
power switch is turned “OFF”. Failure to do so may
result in damage to the electrical circuit or a shock to
the person doing the repair.
The fuse for your MM-E250 is located inside the
baery box. To access it, carefully remove the
baery box by removing the screws on the front and
back of baery box.
Next, nd the fuse which is located on the jumper
between the two baeries. (See Fig 3)
Remove old fuse and replace with 30 Amp
automove fuse. (See Fig 4)
Replace fuse cover. Reinstall baery cover.
4) Fuse Replacement
WARNING
!
14
Valve
Stem
Fuse
Fig 3
Fig 4
Front Screw
Rear Screw