1. Input/Output Voltage Meter: Displays input
or output voltage.
2. Voltage Correction Meter: Continuously displays
the amount of voltage being increased or reduced
to maintain 120 volts.
3. Current Usage Meter: Displays current draw.
4. Ground OK LED: Indicates the wall outlet
that AVS 2000 is plugged into is properly grounded.
5. Surge Protected LED: Indicates AVS 2000’s internal
surge protection is active.
6. Line and Neutral OK LED: Indicates the wall outlet
that AVS 2000 plugged into is properly wired.
7. Normal Voltage Condition: Indicates input voltage
is between 80 and 140 volts.
8. Switched Outlets On LED: Indicates components
plugged into the “switched” outlets will receive
power when the ON button is pressed.
9. Abnormal Voltage Condition: Indicates input
voltage has dropped below 80 volts or has risen
above 140 volts or that the system is waiting
for stabilization.
10. Sequential Power On/Off Button: Press to provide
AC power to switched outlets.
11. Input Voltage/Readout Illumination: Adjusts
the illumination level of the LED meters (depress and hold).
Toggles input/output voltage meter (depress and release).
Figure 1
4
7
1
2
5
8
10
11
6
9
3
AVS 2000 FEATURES
AVS 2000 – FRONT PANEL
To Next Page
