15
4
installation anD setUP
4.1 INSTALLATION GUIDELINES
The following guidelines describe the basics for proper setup and installation of your
Vision Max3D Eyewear, please read through this section carefully so that you are prepared
for all aspects of the installation.
4.1.1 Transmitter Placement
The placement of the transmitter in relation to other electronics that transmit electromagnetic
signal is important. Due to the nature of RF, outside electromagnetic interference can impede
the performance. Be sure and keep the transmitter a good distance from the TV or any device
that can emit electromagnetic signals.
4.1.2 Glasses Placement
Additionally, the Eyewear requires a pre-determined location as they require charging while not in
use. Choose a location that is close to the TV for quick access so that the Eyewear is always close at
hand. This location must be accessible to a power source as described in section 4.2.1 on page 15.
4.2 POWER GUIDELINES
4.2.1 MAX 3D Transmitter Power
While some TVs have USB ports that can provide power to the transmitter, a USB port may
not be available.
In cases such as this other methods for power can be used:
• USB Port on the rear of a Blu Ray player
• USB Port on a computer or USB hub
• Power adapters such as the Monster iSlimCharger
• If a wall outlet is not in close proximity to the location for the transmitter, a USB extension
with the Monster iSlimCharger can be used for this function.
4.2.2 MAX 3D Eyewear Power
The glasses are charged via USB micro B connection located on the bottom of the left support,
power can be supplied via a Type-A USB port on a computer or hub utilizing the included USB cable.
Additionally, the glasses can be charged via a USB port on the TV. Should no USB port on a computer or
the TV be available, a power adapter such as the Monster iSlimCharger can be used for this function.
To Next Page
Loading...