montpellier MDI605 - User Manual

Questions and Answers

J
Jennifer WilliamsAug 16, 2025
What to do if the montpellier Dishwasher programme does not start?
- Z
  zlambAug 16, 2025
  If the montpellier Dishwasher programme doesn't start, there are several potential causes: * The dishwasher might not be plugged in. Ensure it is properly plugged in. * The dishwasher might not be switched on. Press the On/Off button to switch it on. * A fuse might be blown. Check your indoor fuses. * The water inlet tap might be closed. Turn on the water inlet tap. * The dishwasher door might be open. Ensure the door is closed properly. * The water inlet hose and machine filters might be clogged. Check and clear any clogs in the water inlet hose and machine filters.
D
Darrell WilliamsAug 22, 2025
Why does my montpellier MDI605 Dishwasher have water remaining inside the machine?
- L
  Lindsay SmithAug 22, 2025
  If water remains inside your montpellier Dishwasher, it could be due to these reasons: * The water drain hose is clogged or twisted. Check the drain hose and either clean or untwist it. * The filters are clogged. Clean the filters. * The programme is not finished yet. Wait until the programme is finished.
D
denisewhiteAug 25, 2025
Why does my montpellier MDI605 leave whitish stains on dishes?
- L
  Linda SandersAug 26, 2025
  If your montpellier Dishwasher leaves whitish stains on dishes, here are a few reasons why: * Not enough detergent is being used. Make sure to use the correct amount of detergent as instructed in the programme table. * The rinse aid dosage and/or water softener setting are set too low. Increase the rinse aid and/or water softener level. * The water hardness level is too high. Increase the water softener level and add salt. * The salt compartment cap is not closed properly. Ensure the salt compartment cap is closed tightly.
O
ocruzAug 28, 2025
Why montpellier MDI605 Dishwasher stops during washing?
- P
  Patricia BlackAug 28, 2025
  If your montpellier Dishwasher stops during washing, it may be due to: * A power failure. Check the mains power. * A water inlet failure. Check the water tap.
P
pittstonyaAug 31, 2025
Why montpellier Dishes do not dry after washing?
- T
  Terri WalkerAug 31, 2025
  If dishes do not dry in your montpellier Dishwasher, the possible reasons are: * The drying option is not selected. Select a programme with a drying option. * The rinse aid dosage is set too low. Increase the rinse aid dosage setting.
R
Rickey YoungSep 3, 2025
What to do if detergent remains in the detergent compartment of my montpellier MDI605?
- B
  Brian MurphySep 3, 2025
  If detergent remains in the detergent compartment of your montpellier Dishwasher, it's likely because the detergent was added when the compartment was wet. Make sure the detergent compartment is dry before use.
T
Tracie HoffmanSep 6, 2025
What to do for montpellier Dishwasher water inlet system failure?
- C
  Craig SmithSep 6, 2025
  In case of a water inlet system failure with your montpellier Dishwasher: * Make sure the water inlet tap is open and water is flowing. * Separate the inlet hose from the tap and clean the filter of the hose. * Contact for service if the error continues.
E
Eric ScottSep 9, 2025
How to fix rust stains on dishes in montpellier MDI605?
- L
  littlejoannSep 9, 2025
  If rust stains form on the dishes in your montpellier Dishwasher, consider these points: * The stainless-steel quality of the dishes may be insufficient. Use only dishwasher-proof sets. * There may be a high level of salt in the wash water. Adjust the water hardness level using the water hardness table. * The salt compartment cap may not be closed properly. Check that the salt compartment cap is closed properly. * Too much salt may have spilled in the dishwasher while filling it. Use a funnel while filling salt to the compartment to avoid spillage. * There might be a poor mains grounding. Consult a qualified electrician immediately.
L
Linda ThompsonSep 12, 2025
How to fix shaking and hitting noises during montpellier MDI605 Dishwasher wash?
- E
  erinjonesSep 12, 2025
  If you hear shaking and hitting noises during a wash operation in your montpellier Dishwasher: * The spray arm might be hitting the dishes in the lower basket. Move or remove items blocking the spray arm. * Adjust the height of the top basket.
C
Caroline MooneyNov 18, 2025
Why does my montpellier MDI605 Dishwasher leave partial food wastes on the dishes?
- J
  Jon WrightNov 18, 2025
  If your montpellier Dishwasher leaves partial food wastes on the dishes, consider these possible causes and solutions: * Dishes may be placed incorrectly, preventing sprayed water from reaching them. Avoid overloading the baskets. * Dishes may be leaning against each other. Place dishes as instructed in the section on loading your dishwasher. * Not enough detergent may be used. Use the correct amount of detergent, as instructed in the programme table. * The wrong wash programme may be selected. Use the information in the programme table to select the most appropriate programme. * Spray arms may be clogged with food waste. Clean the holes in the spray arms with thin objects. * Filters or the water drain pump may be clogged, or the filter may be misplaced. Check that the drain h...