34
USING SPECTRAVOX AS A EURORACK MODULE
Your Spectravox can be removed from its case and easily installed into a Eurorack system as a 60HP
module. Before doing this, it is important to note that Spectravox draws a maximum of 450 mA from
a +12V supply. It does not use the -12V supply at all. Make sure there is enough headroom on the +12V
supply in your system to power Spectravox.
NOTE: You will need to know the current rating of the system’s +12VDC supply and the current draw of the
+12VDC supply from all modules in the system combined. The sum of all current draw at +12VDC should never
exceed the power supply rating. It is good practice to leave some headroom to reduce stress on the supply.
Moog Music accepts NO responsibility or liability for improperly installed modules.
HOW TO INSTALL SPECTRAVOX IN A EURORACK SYSTEM
1. Disconnect external power from the unit.
2. Remove the eight black M3 screws on the front panel and keep them somewhere safe. You will need
them again.
3. Slowly lift the panel from the case, so that you can see the two cables going to the front panel module.
4. Disconnect these two cables from the front panel. The module is now free from its enclosure.
5. Look at the back of your Spectravox.
There is a 10-pin power header on the back
of the PCB that accepts a 10-pin Eurorack
power ribbon cable (not included).
6. Connect PIN-1 (-12V) of the power ribbon
cable to PIN-1 of the Spectravox Eurorack
power header. The darkened wire (typically
red) on the ribbon cable indicates the PIN-1
(-12V) side of the cable.
7. After power is connected, your Spectravox
may be installed into the rails of the Eurorack
system case with the eight black M3 screws
removed in Step 2.
8. Once fully installed, you may power up
your Eurorack system.
To Next Page
Loading...
