Moog Subharmonicon - Page 14

Outputs | 14
Outputs
VCA (R1, C4)
Output of the final VCA
This can be used to integrate
Subharmonicon with Eurorack gear for
further processing, or routed back into
Subharmonicon for feedback patches.
Try routing it to either VCO or the
CUTOFF for noisy modulation.
VCO 1 (R2, C1)
Audio output of VCO 1
Try routing to VCO 2 for frequency
modulation, VCA for amplitude
modulation, or route to CLOCK for audio
rate clocking. You can also use this output
to take VCO 1 direct to external gear,
bypassing the VCF and VCA.
VCO 1 SUB 1 (R2, C2)
Audio output of VCO 1 Sub-oscillator 1
Try routing to any of the RHYTHMS for
rhythm modulation, the VCA for amplitude
modulation, or CLOCK for a clock with
voltage control.
VCO 1 SUB 2 (R2, C3)
Audio output of VCO 1 Sub-oscillator 2
See VCO 1 SUB 1.
VCA EG (R3, C4)
Envelope output of the VCA envelope
generator
This is normalled to the VCA input, but try
routing to any VCO for enveloping FM or a
RHYTHM for complex sequencer motion.
Listed in order left to right by row;
R (Row) and C (Column)