21
0688-SOM-00001, Rev: 02 © Tritech International Ltd.
6. Care and Maintenance
Warning
Opening of the unit will void the warranty. This unit is not designed to be
field serviceable. Calibration and pressure certification will also become invalid
should the unit be opened.
6.1 After using the Super Seaking 700
We recommend that the unit be rinsed down with fresh water after each dive, especially if the unit is not intended
to be used for an extended period. The anodised housing and plastic components are resistant to corrosion,
using fresh water is a simple way ensuring the longevity of the system.
The temperature / conductivity sensor should be cleaned to remove any build-up of dirt, oil, mud or sediment.
Any build up may reduce sensitivity and affect accuracy of measurements. This can be done with a with a plastic
bottle brush or similar.
Wherever possible try to avoid prolonged exposure to extreme climatic and weathering conditions so as to
reduce the wear and aging of components and connectors.
6.2 Seaking Basic Maintenance
It is recommended the o-rings and connector o-rings be inspected regularly to ensure they are in good condition.
Worn or damaged o-rings should be replaced and greased. The Bathy should be visually inspected and cleaned
regularly.
6.3 Field Service
The Super SeaKing is not designed to be field serviceable, unauthorised opening of the housing will void the
warranty, pressure and calibration.
6.4 Storage
Make sure the Super Seaking 700 is completely dry (if necessary leave to dry in air before stowing). Pack into
storage container along with several pouches of silica gel.
6.5 Calibration
The Super Seaking 700 should receive an annual service and calibration check, so its recommended that the unit
be returned to Tritech International Ltd for this purpose.
To Next Page
Loading...
Need help?
General