Mooney M20V - Page 471

MOONEY INTERNATIONAL CORPORATION
M20V SERVICE AND MAINTENANCE MANUAL
Date
MAR 2017
Rev Date
Page
7
SHIM/HARDW ARE TABLE
SHIM DASH NO. BOLT NO.
BOLTS
PER SHIM
WASHER NO. WASH-
ERS REQD.
PER SHIM
WASHER
(ADDITIONAL)
NO. NUTS
REQD. PER
SHIM
310136- 7 AN4- 5A 4 AN960- 416
L
8 AN960- 416L AN363- 428
310134- 9 AN4- 5A 4 AN960- 416
L
8 AN363- 428
310134- 11 AN4- 5A 4 AN960- 416
L
8 AN363- 428
310134- 13 AN4- 6A 4 AN960- 416 8 AN363- 428
310134- 15 AN4- 6A 4 AN960- 416 8 AN363- 428
- AN4- 6A 4 AN960- 416 4 AN363- 428
TORQUE VALUES
NUT & BOLT SIZE TORQUE VALUE
(INCH- POUNDS)
AN 3 20- 25
AN 4 50- 70
AN 6 100- 140
AN 7 450- 500
WING ATTACHING HARDWARE CHART
FIGURE 57- 2A
LEFT WING - SHOWN
RIGHT WING - OPP.
STA. 43.5 - RIB RIVET LINE
STA. 60.12
FWD
2.0
A
SKIN
STALL STRIP
A
AN520- 6- 7 SCREW
AN345- 6 NUT
AN960 - 6 WASHER
FWD
NOTE:
FILL ALL SCREW HEAD
HOLES WITH FEATHERFILL,
SAND SMOOTH & PAINT
TO MA TCH WING.
NOTE:
FILL ALL SCREW HEAD
HOLES WITH FEATHERFILL,
SAND SMOOTH & PAINT
TO MATCH WING.
FWD
C’BORE STALL
STRIP .406”
.06/.10” DEEP
AN515- 6R10
SCREW - USE
LOCKTITE TYPE CV
WING
A
STALL STRIP
DRILL .189/.193 DIA
USE A6- 75 RIVNUT
ALTERNATE
INSTALLATION
FWD
NOTE:
FILL ALL RIVET HEAD
HOLES WITH BONDO & FEATHERFILL,
SAND SMOOTH & PAINT
TO MATCH WING.
WING
A
STALL STRIP
DRILL .136/.139 HOLE IN WING SKIN
USE 1693-0410 RIVET
ALTERNATE
INSTALLATION
SKIN
SKIN
PREFERRED
STALL STRIP INSTALLATION
FIGURE 57-2
57-10-00