2
12) CAUTION: To ensure continued protection against shock hazard, use only identical replacement parts
when servicing
13)This pump is for use with permanently installed in-ground or above-ground swimming pools and may
also be used with hot tubs and spas with a water temperature under 50℃. Due to the fixed installation
method, this pump is not suggested to be used on above-ground pools that can be readily disassembled
for storage.
14) The pump is not submersible.
15) Never open the inside of the drive motor enclosure.
16) SAVE THESE INSTRUCTIONS.
WARNING:
• Fill the pump with water before starting. Do not run the pump dry. In case of dry run, mechanical seal
will be damaged and the pump will start leaking.
• Before servicing the pump, switch OFF power to the pump by disconnecting the main circuit to the
pump and release all pressure from pump and piping system.
• Never tighten or loosen screws while the pump is operating.
• Ensure that the inlet and outlet of the pump are unblocked with foreign matter.
To Next Page
Loading...
