Pro Sensor Models M1017--- (Water)
INTENDED USE OF THE M1017 SENSOR IS TO MEASURE THE AMOUNT OF LIQUID WATER INSIDE A WATER
TANK MEETING THE SPECIFATIONS BELOW, UNDER THE CONDITIONS LISTED BELOW.
THIS DEVICE IS INTENDED FOR OUTDOOR USE ONLY.
WARNING
USE OF THIS DEVICE IN A MANNER OTHER THAN STATED IN THIS MANUAL, MAY RESULT IN IMPAIRMENT OF
THE DESIGNED SAFETY PROTECTION AND THUS AN UNSAFE CONDITION.
Water, Gray Water. NOTE FOR BLACK WATER OR OTHERWISE
HEAVILY CONTAMINATED WATER.
Steel, Aluminum, Plastic
Not intended for use on composite tank materials.
Up to 48-inch fluid height
73 mm Diameter x 7.3 mm Thickness (2.87 x 0.29 inches)
OPERATING TEMPERATURE RANGE
ONE, CR2032 COIN CELL (3V)
WARNING
THIS DEVICE IS NOT TO BE REPAIRED OR OTHERWISE MODIFIED.
MOPEKA PRODUCTS LLC
MAILING ADDRESS: 1223 INDUSTRIAL DR, SUITE A; NEW BRAUNFELS, TX 78130
www.mopeka.com
support@mopeka.com
To Next Page
Need help?
General
