1
Step 1
Ensure your floor is properly protected.
Take out 3 pieces of Table Leg (2) and 3 pieces of
Support Bar (3).
Attach Table Leg (2) with Support Bar (3)
Illustration 1:
Please ensure that you install the correct side of
Support Bar (3). The side with holes of larger
diameter (14mm) should face the longer end of Table
Leg (2).
Illustration 2:
Plug in Barrel Nut (F) into hole as indicated. Ensure
that the hole is facing the right directtion to the bolt.
Slide in Spring Washer (D) and Flat Washer (E) onto
JCBC Screw (B). Insert this screw combination into
the holes as indicated. Tighten with Allen Key (A).
If you have difficulties aligning JCBC Screw (B) and
Barrel Nut (F), try shaking or readjusting the Barrel
Nut (F) position using a screwdriver.
Ensure that you screw into the correct holes
according to the illustration.
A
x1
D
x6
E
x6
B
x6
F
x6
Step 2
DYLAN NESTING
COFFEE TABLE SET | 06
A
x1
D
x6
E
x6
C
x6
1
D
E
A
C
Ensure your floor is properly protected.
Use cardboard or styrofoam to prevent
damages.
Take out Table Top (1).
Install Table Top (1) to Support Bar (3).
Slide in Spring Washer (D) and Flat Washer
(E) onto JCBC Screw (C). Insert this screw
combination into the holes as indicated.
Tighten with Allen Key (A).
Please ensure you screw into the correct
holes according to the illustration.
Missing parts? Or feeling stuck?
Contact us at www.mopio.com#chat.
Watch demo video at:
https://bit.ly/3BrQgaC
3
2
F
D
E
A
B
F
x 3
Illustration 1
Illustration 2
Small hole
8mm
Large Hole
14mm
To Next Page
Loading...
