mopio Haylee - Step 13: Sliding Door Installation

TV
STAND, 59" | 12
T
x1
8
8
T
C
Top
Bottom
Reverse the table body and let it stand upwards to install the
sliding door. You may need extra pair of hands to reverse the
table body.
Insert the door panel's top sliding pin to the groove
underneath the top table board. While holding its position,
insert the bottom sliding roller to the groove on the bottom
board. When all pins are in the right position completely,
release the door.
The sliding door is adjustable. If there is any misaligned gap or
diculty in sliding, you may adjust the sliding roller to your
preferred position.
Peel buer sticker T and stick 1 piece
to each side of the door panel, at the
end of the middle slat.
Step 13