User instructions
1. To light the hotplate push In the appropriate control knob and
turn anti-clockwise to the large ame symbol (g. 8).
2. Keep the knob depressed until the burner lights.
3. Turn the tap to the required setting.
4. In the event of the burner ames being accidentally
extinguished, turn o the burner control and don’t attempt to
reignite the burner for at least 1 min.
NOTE: Matches can be used to light the burners in the event of
a power failure. Keep the control knob pressed in for 15 seconds
ensuring the burner stays lit when released. If the burner fails to
stay lit wait for 1 minute before relighting.
Fig 9
Closed position
Full on position
Reduced rate position
Fig 8
Use an appropriately sized pan and with at bottom for each
burner (see the table below and g. 9).
When the contents of the pan start to boil, turn the knob down to
reduced rate position. Always put a lid on the pan.
Burners Rapid
3000W
Semirapid
1750W
Auxilary
1000W
Φpans in cm 20-22 16-18 10-14
SELECT THE RIGHT
BURNER
10
To Next Page
Loading...
