Need help?Do you have a question about the More NF18MESH and is the answer not in the manual?
The gateway is for indoor use only and should be placed centrally for best WiFi performance.
Ensure proper ventilation around the gateway, maintaining at least 5cm clearance.
Avoid direct sunlight, hot areas, and contact with liquids or moisture.
Use only the provided power supply unit; stop use if damaged.
The gateway has no user-serviceable parts; do not attempt repair or modification.
Keep gateway and accessories away from children due to small parts and sharp edges.
Gateway conforms to RF exposure limits when used at least 20 cm from the body.
Handle with care, avoid open flames, drops, and harsh chemicals.
The device is pre-configured; follow steps for FTTC NBN connection.
Find the NBN-activated telephone wall socket in your property.
Disconnect all devices from telephone sockets to avoid NBN signal interference.
Connect the NBN Connection Device (NCD) to the activated socket and power it up.
Connect the Netcomm modem to the NBN Connection Device using the blue WAN port.
Leave modem connected for NBN activation (20 mins to 1 hour).
Verify Power, WAN & WiFi lights are steady green, Internet light is flashing.
Advice for DSL light issues, checking connections, and waiting for activation.
Contact details for technical assistance via phone, overseas, and WhatsApp.
Wait 20 mins for device connection, then test speed at www.speedtest.net.
Instructions for connecting when the device is not pre-configured.
Ensure you have your internet service connection details and settings on hand.
Explains Ethernet WAN and ADSL/VDSL connection methods.
Complete a factory reset of the modem before proceeding.
Open a browser and navigate to cloudmesh.net or 192.168.20.1.
Enter 'admin' for username and the password from the gateway label.
The gateway displays the wizard; recommended to configure the internet connection.
Configure Internet Service as Ethernet WAN and Connection Type as PPPoE.
Enter PPPoE or Dynamic IP details, then click Next for wireless settings.
Configure Static IP or Bridge connection details and proceed.
Set Network Name (SSID) and WiFi Password for 2.4GHz and 5GHz networks.
Optional configuration for VoIP telephone lines, enter SIP details if used.
Highly recommended to change default username and password for router access.
Select the correct timezone for accurate timekeeping and log functions.
Review entered information and click Finish to complete the setup.
To Next Page
General