20
ENGLISH
INSTALLATION
1. Place the pump on a flat surface or hang it where you can by means of the hooks
2. Connect the tubes to the pump and to the arm/leg garment. Ensure the air hoses are not
kinked or tucked under mattress
3. Plug the power cord into the electrical outlet
4. Turn the switch ON
BEFORE USE
Check the correct assembly, paying particular attention to air hoses connector
- Check for any damage to the garments, which can compromise the operation
- Check the zippers correctly work
WARNING!
• Make sure the punp unit is suitable for the local power voltage
• Do not position the equipment so that is difficult disconnect the plug
.1
.2
.3
.4
MA LTM500_3 02 A.indd 20 05/09/12 15:13
To Next Page
Loading...