Morgan Olson C-250 - Pairing a Fob

Driver FOB
Detection
Zone
Pairing a fob
1. If the vehicle has been left with its doors open, close and reopen at least one
door before continuing to wake the vehicle.
2. Bring the paring fob and the fob-to-be-pared, into the driver’s seat area.
3. Press and hold both the brake pedal and the unlock button for 10 seconds.
• The vehicle will try to detect the p a i r i n g -f o b .
•
If detected, vehicle will respond by blinking the start/stop button’s LED at a high rate (toggle
every 100ms)
• Vehicle will stay in fob paring mode for 60 seconds if no action is taken. It will indicate the
end of paring mode by not blinking the LED.
• You can also exit the paring mode by releasing the brake pedal and the unlock button, then
pressing the start/stop button.
4. R e l e a s e the brake p e d a l and unlock bu tt on.
5. Using the fob-to-be-pared, press and hold the fob button for 10 seconds.
6. Vehicle will respond with:
• Success–Two“2secondon,twosecondo󰀨”pulsesofthestart/stopbutton’sLEDif
successful.
• Fobmemoryfullerror–Four“2secondon,0.5secondo󰀨”pulsesiftherearenomore
fob pairing slots free.
• Anyotherfailure-Two“5secondon,5secondo󰀨”pulsesifparingwasunsuccessful
for any other reason.
• Afterashsequence,vehiclewillexittheparingmode.
C-250 Keyless Guide 09/2023
www.morganolsonparts.com